Switch Management Commands 1992User GuidelinesAuto enables the switch to deliver power to the powered device. The powerinline management parameter should be set to class-based mode to enablepower negotiation via LLDP-MED. Dell EMC Networking PoE-enabled portsshould not be connected to other Power Sourcing Equipment (PSE) with PoEenabled. If the switch detects PSE equipment supplying power to a port, PoEpower is disabled on the port. If a port supplying power issues an input powerdetected (0x24) status and no device is attached, the port should not be usedas a possible short may exist.Default ValueThe default value is auto, that is, device discovery is enabled and the port iscapable of delivering power.Examplesconsole(config)#interface gigabitethernet 1/0/1console(config-if-Gi1/0/1)# power inline autopower inline detectionUse the power inline detection command to configure the detection typethat tells which types of PD’s will be detected and powered by the switch. Usethe no form of this command to set the detection type to the default.Syntaxpower inline detection [unit unit-id]{dot3at|dot3at+legacy}no power inline detection• dot3at—IEEE 802.3at 4-point detection only.• dot3at+legacy—IEEE 802.3at 4-point detection followed by legacycapacitive detection.• unit unit-id—The specific stack member to be configured.Default ConfigurationThe default value is dot3at+legacy.
