Audio Visual Bridging Commands 1111User GuidelinesIEEE 802.1AS propagates time information from master clocks andsynchronizes internally with the clock in support of delivering streams to thedestination device with the same relative timing as sampled at the source.All IEEE 802.1AS interfaces must reside on the same stack member.Propagation of timing information across a stack is not supported.IEEE 802.1AS must also be enabled on individual interfaces to becomeoperational.This command is only available on the N4000 Series switches.Command HistoryIntroduced in version 6.2.0.1 firmware.Exampleconsole(config)#dot1asdot1as (Interface Configuration)Use this command to enable IEEE 802.1AS on an interface. Use the no formof the command to disable IEEE 802.1AS on an interface.Syntaxdot1asno dot1asDefault ConfigurationBy default, IEEE 802.1AS is disabled globally and on all interfaces.Command ModeInterface ConfigurationUser GuidelinesIEEE 802.1AS propagates time information from master clocks andsynchronizes with the internal clock in support of delivering streams to thedestination device with the same relative timing as sampled at the source.
