Audio Visual Bridging Commands 1117Command ModeInterface ConfigurationUser GuidelinesThis value is the logarithm to the base 2 of the desired mean time intervalbetween successive Pdelay_req messages sent by the link peer.IEEE 802.1AS must also be enabled globally as well as on an interface tobecome operational.Command HistoryIntroduced in version 6.2.0.1 firmware.ExampleThis example configures the switch with an initial log sync interval of 3.console(config-if-Gi1/0/1)#dot1as interval pdelay 3console(config-if-Gi1/0/1)#show dot1as interface gi1/0/1AS Interface Admin Mode................... EnabledAS Capable................................ NoIs Measuring Delay............................. NoPropagation Delay.............................. 0Port Role...................................... DisabledPDELAY Threshold............................... 2500PDELAY lost responses allowed.................. 3Neighbor Rate Ratio............................ 0Initial Sync Interval.......................... 3Current Sync Interval.......................... -3Initial Pdelay Interval........................ 3Current Pdelay Interval........................ 0Initial Announce Interval...................... 3Current Announce Interval...................... 0Sync Receipt Timeout........................... 3Announce Receipt Timeout....................... 3dot1as timeout announceUse this command to configure the number of announce intervals expirieswith no received announce message in which case the master is considered tobe no longer transmitting. Use the no form of the command to return theannounce expiries to the default.
