Switch Management Commands 1939User GuidelinesMessages are shown for both the accept and reject use cases with informationdirecting the user to URLs for further information. If the user rejects or hasnot yet accepted the EULA, the configuration mode for the specified serviceis not usable. If there is existing configuration for that feature, theconfiguration is not removed, but the feature is disabled.This command can be executed multiple times. It overwrites the previousinformation each time. The collected information is stored in the running-config. The administrator must write the configuration in order to persist itacross reboots. If the administrator clears the config, this information mustbe reconfigured.Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole(config)# eula-consent hiveagent acceptThis switch includes a feature that enables it to work with HiveManager (anoptional management suite), by sending the switch’s service tag number toHiveManager to authenticate your entitlement to use HiveManager. If you wishto disable this feature, you should run command “eula-consent hiveagentreject” immediately upon powering up the switch for the first time, or at anytime thereafter.console(config)# eula-consent hiveagent rejectI do not accept the terms of the license agreement. The HiveAgent feature hasbeen deactivated and can no longer be used. To enable HiveAgentconfigurations, accept the terms of the license agreement by configuring thiscommand 'eula-consent hiveagent accept'.hiveagentUse the hiveagent command to access the HiveAgent configuration mode.Use the no form of the command to remove the configured Dell HiveAgentinformation.Syntaxhiveagent
