Security Commands 892Default ConfigurationE-mail alerting is disabled by default. When e-mail alerting is enabled, logmessages at or above severity Warning are e-mailed.Command ModeGlobal Configuration modeUser GuidelinesThe logging email command with no arguments enables e-mail alerting.Specify a severity to set the severity level of log messages that are e-mailed ina non-urgent manner. Log messages at or above this severity level, but belowthe urgent severity level, are collected together until the log time expires (thetime specified in the logging email logtime command) and then e-mailed in asingle e-mail message. If you set the non-urgent severity level to the samevalue as the urgent severity level, then no log messages are e-mailed non-urgently. See the logging email urgent command to specify the urgent severitylevel. The command no logging email disables all e-mail alerting.logging email urgentUse the logging email urgent command in Global Configuration mode to setthe lowest severity level at which log messages are e-mailed in an urgentmanner. To revert the urgent severity level to its default value, use the noform of this command.Syntaxlogging email urgent {severity | none}no logging email urgent• severity—If you specify a severity level, log messages at or above theseverity level are e-mailed. The severity level may either be specified bykeyword or as an integer from 0 to 7. The accepted keywords, and thenumeric severity level each represents, are as follows.– emergency (0)– alert (1)– critical (2)
