Security Commands 922console(config)#radius-server attribute 4 192.168.10.22radius-server attribute 6Use the radius-server attribute 6 command to configure the use of theRADIUS Service-Type attribute.Syntaxradius-server attribute 6 [on-for-login-auth|mandatory]no radius-server attribute 6 [on-for-login-auth|mandatory]Default ConfigurationBy default, the switch does not send the Service-Type attribute to theRADIUS server in the Access-Request packets. By default, the switch ignoresthe Service-Type received in Access-Accept packets.Command ModeGlobal ConfigurationUser Guidelineson-for-login—This parameter globally configures the switch to send theRADIUS Service-Type attribute in the Access-Request message sent to allRADIUS authentication servers. The switch sends the Service-Type valueAdministrative (6) for administrators attempting to access the switch consoleand sends Service-Type value Login (1) for users attempting to access thenetwork.mandatory—This parameter enables processing and validation of the Service-Type parameter received from the RADIUS server in Access-Accept messages.Dell EMC Networking N-Series switches accept the Login-User (1) orAdministrative-User (6) values in the Access-Accept message returned fromthe RADIUS server. Access-Accept messages without one of those values aretreated as if an Access-Reject message has been received.Command HistoryIntroduced in version 6.3.0.1 firmware. Updated in 6.3.0.5 firmware.
