Layer 2 Switching Commands 441green-mode energy-detectThis command enables a Dell EMC proprietary mode of power reduction onports that are not connected to another interface. Use the green-modeenergy-detect command in Interface Configuration mode to enable energy-detect mode on an interface or all the interfaces. Energy-detect mode isenabled by default on 1G copper interfaces and enabled by default on 10Gcopper interfaces.On combo ports, it is possible to configure energy-detect mode even if thefiber port is enabled. If enabled, energy-detect mode will become active whenthe copper port is used.Use the no form of the command to disable energy-detect mode on theinterface(s).Syntaxgreen-mode energy-detectno green-mode energy-detectDefault ConfigurationOn N1100-ON, N1500, N2000, N2100-ON, N3000, and N3100-ON switches,energy-detect is enabled by default. Energy detect mode is enabled by defaultand cannot be disabled on N4000 10G copper interfaces.Command ModeInterface Configuration modeUser GuidelinesThis command is available in Ethernet interface configuration mode. Cablediagnostics (show copper-ports tdr command) may give misleading results ifgreen mode is enabled on the port. Disable green mode prior to running anycable diagnostics. EEE and energy-detect modes are only supported on N4000green-mode eee show green-modedescription show green-mode eee-lpi-history interfacegreen-mode eee-lpi-history –
