Audio Visual Bridging Commands 1097Command ModeInterface Configuration, Interface rangeUser GuidelinesThe VLAN must be configured on the interface is order to carry traffic. Theinterface must be configured to carry tagged traffic (i.e., trunk mode).MSRP must also be enabled globally in order to become operational.Command HistoryIntroduced in version 6.2.0.1 firmware.ExampleThis example configure MSRP traffic on interface Gi1/0/2 for VLAN 12console(config)#interface gi1/0/2console(config-if-Gi1/0/2)#msrpconsole(config-if-Gi1/0/2)#msrp srclass-pvid 12msrp srclassqavUse this command to configure the IEEE Qav class priority map. Use the noform of the command set the class configuration to the default.Syntaxmsrp srclassqav class [a | b] [pcp | remap] 0-7no msrp srclassqav class [ a | b ]• class a | b—Specifies the class to be configured. Dell EMC Networkingswitches support class A and class B priorities.• pcp—Specifies the priority of the selected MSRP traffic class. The range is0–7. This is the value received in the Ethernet frame for trusted ports orassigned by the system as a default.• remap—Specifies the priority of the non-AVB traffic with AVB traffic classPCP. The range is 0–7. This is the priority to which traffic is remapped.Default ConfigurationThe defaults for the traffic classes are:
