Switch Management Commands 1964User GuidelinesThis command only applies to VLAN routing interfaces. When DHCPv6 isenabled on a VLAN routing interface, the system automatically deletes allmanually configured IPv6 addresses on the interface.Use the no ipv6 address dhcp command to release a leased address and todisable DHCPv6 on an interface. The command no ipv6 address does notdisable the DHCPv6 client on the interface.This command will fail if DHCPv6 server has been configured on theinterface.ExamplesIn the following example, DHCPv6 is enabled on interface vlan2.console#configconsole(config)#interface vlan 2console(config-if-vlan2)#ipv6 address dhcpipv6 enable (Interface Configuration)Use the ipv6 enable command in Interface Configuration mode to enableIPv6 on a routing interface. Use the no form of this command to reset theIPv6 configuration to the defaults.Syntaxipv6 enableno ipv6 enableDefault ConfigurationIPv6 is not enabled by default.Command ModeInterface Configuration mode (VLAN, tunnel, loopback)User GuidelinesThere are no user guidelines for this command.
