Data Center Technology Commands 1171console(config-of-switch)#controller ipv4 1.2.3.4 port 3435 security sslshow openflowUse the show openflow command to display OpenFlow configuration andstatus.Syntaxshow openflow [ switch controllers | switch flows | switch groups | switchtables ]• switch controllers—Show information about configured controllers• switch flows—Show information regarding flows• switch groups—Show information regarding OpenFlow groups• switch tables—Show information regarding the switch tablesDefault ConfigurationWhen invoked with no parameters, the show openflow command showssummary information regarding OpenFlow.Command ModePrivileged Exec and Global ConfigurationUser GuidelinesOpenFlow operates on the stack master only. Flows may not be configured onstack members. Failover to the stack standby unit is not supported.OpenFlow should only be enabled on stand-alone switches and should not beenabled on stacks of switches. This restriction is not enforced.The command has the following output.Parameter DescriptionAdministrative Mode The OpenFlow feature administrative mode set by the‘openflow enable’ command.Administrative Status The operational status of the OpenFlow feature. Althoughthe feature may be administratively enabled, it could beoperationally disabled due to various reasons.
