Switch Management Commands 2183where weight = 2 / ((TotalTimePeriod/samplePeriod) + 1). The sampleperiod is 5 seconds. The utilization monitoring time period can be configuredfrom 5 secs to 86400 seconds in multiples of 5 seconds.Setting a threshold or interval to 0 disables that individual function.The falling-threshold percentage should be configured to be less than orequal to the rising-threshold percentage. The switch reports the task levelCPU utilization for the last 5 second, 1 minute and 5 minute periods. To aidthe operator in troubleshooting when the CPU utilization has crossed therising threshold, the show proc cpu command has been extended to show thetask/total CPU utilization for the rising threshold period also. If theutilization thresholds are not configured, then the utilization for last 5 secs, 1minute and 5 minutes is displayed as before. The CPU utilization for anygiven period is displayed in only after the first average has been calculatedover the time period.For instance, the 5 minute average is shown only after the switch has been upfor more than 5 minutes. Additionally, whenever a time-period is configuredfor CPU utilization monitoring, the existing utilization data for the time-period is cleared and average is built again over the time period. This is doneto prevent generation of notifications based on the old utilization data.Command HistoryIntroduced in version 6.2.0.1 firmware.Exampleconsole(config)#process cpu threshold type total rising 90 interval 100quitUse this command to disconnect the serial connection to the remote unit onthe stack member.SyntaxquitDefault ConfigurationThere is no default configuration for this command.
