Switch Management Commands 1942no enableDefault ConfigurationBy default, the default server is enabled. It may be disabled using the noenable form of the command.Command ModeHiveAgent Server ConfigurationUser GuidelinesOnly one HiveAgent server (HiveManager NG) can be enabled.Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole(config)# hiveagentconsole(conf-hiveagent)#server HiveManagerNGconsole(conf-hiveagent-HiveManagerNG)#enableproxy-ip-addressUse the proxy-ip-address command to configure a proxy server to be used tocontact the HiveManager NG. Use the no form of the command to removethe proxy server information.Syntaxproxy-ip-address {ipv4-address | ipv6-address} port port-number usernameuserid password [encryption-type] passwordno proxy-ip-address• ipv4-address — The IPv4 address of the proxy server in dotted decimalnotation.• ipv6-address — The IPv6 address of the proxy server in IPv6 notation.• port-number — The TCP port number of the proxy server. The range is1–65535. The default is 443.• userid — The user name used to log into the proxy server.
