Switch Management Commands 1965Exampleconsole(config)#no ipv6 enableipv6 enable (OOB Configuration)Use the ipv6 enable command in Interface (out-of-band) Configurationmode to enable IPv6 operation on the out-of-band interface. Prefixesconfigured by the ipv6 address command are not configured until theinterface is enabled.Syntaxipv6 enableno ipv6 enableDefault ConfigurationBy default, IPv6 is not enabled on the out-of-band port.Command ModeInterface (out-of-band) Configuration modeUser GuidelinesThis command is not necessary if an IPv6 address has been assigned to theinterface. This command is only valid for switches equipped with an out-of-band interface.ipv6 gateway (OOB Configuration)Use the ipv6 gateway command in Interface (out-of-band) Configurationmode to configure the address of the IPv6 gateway. The gateway is used as adefault route for packets addressed to network devices not present on thelocal subnet. Use the no form of the command to remove the gatewayconfiguration.Syntaxipv6 gateway ipv6-addressno ipv6 gateway
