Switch Management Commands 2053Command ModePrivileged Exec mode.User GuidelinesThe VRF identified in the parameter must have been previously created or anerror is returned.Only IPv4 addresses are supported with the vrf parameter.This command is only available on the N3000/N3100/N4000 switches.Debug output should be enabled with caution. Switch behavior may beadversely affected by the additional processing load incurred from enablingdebug.Exampleconsole#debug ospf packetdebug ospfv3Use the debug ospfv3 command to enable tracing of OSPFv3 packetsreceived and transmitted by the switch. Use the “no” form of this commandto disable tracing of OSPFv3 packets.Syntaxdebug ospfv3 packetno debug ospfv3 packetDefault ConfigurationDisplay of OSPFv3 traces is disabled by default.Command ModePrivileged Exec mode.User GuidelinesDebug output should be enabled with caution. Switch behavior may beadversely affected by the additional processing load incurred from enablingdebug.
