Layer 3 Routing Commands 1600Default ConfigurationThere is no default configuration for this command.Command ModePrivileged Exec mode, Global Configuration mode and all ConfigurationsubmodesUser GuidelinesThis command does not clear static multicast route entries.When a * entry is deleted through this command, it cannot be formed againuntil it is expired in MLD and started again via the host. The default mcachetime-out is 210 seconds.ExampleThe following example deletes all entries from the IPv6 multicast routingtable:console# clear ipv6 mroute *The following example deletes from the IPv6 multicast routing table allentries that match the given multicast group address (FF4E::1), irrespectiveof which source is sending for this group:console# clear ipv6 mroute FF4E::1The following example deletes from the IPv6 multicast routing table allentries that match the given multicast group address (FF4E::1) and themulticast source address (2001::2):console# clear ipv6 mroute FF4E::1 2001::2ipv6 pim (VLAN Interface config)Use the ipv6 pim command in VLAN Interface configuration mode toadministratively enable PIM multicast routing mode on a particular IPv6router interface. Use the no form of this command to disable PIM on aninterface.Syntaxipv6 pim
