Layer 3 Routing Commands 1342Modified in version 6.3.0.1 firmware.show bgp ipv6 route-reflectionUse this command to display a summary of BGP route reflection. Thiscommand deprecates and replaces the show ipv6 bgp route-reflectioncommand.Syntaxshow bgp ipv6 route-reflectionDefault ConfigurationThere is no default configuration for this command.Command ModePrivileged Exec mode, Global Configuration mode and all ConfigurationsubmodesUser GuidelinesIf a route reflector client is configured with an outbound route map, theoutput warns that set statements in the route map are ignored whenreflecting routes to this client.The following information is displayed.Field DescriptionCluster ID The cluster ID used by this router. The value is taggedas configured when the value is configured with the bgpcluster-id command. When no cluster ID is configured,the local router ID is shown and tagged as default.Client-to-Client Reflection Displayed as Enabled when this router reflects routesreceived from its clients to its other clients. Disabledotherwise.Clients A list of this router’s internal peers which have beenconfigured as route reflector clients.
