Layer 2 Switching Commands 535iSCSI Optimization borrows ACL lists from the global system pool. ACL listsallocated by iSCSI Optimization reduce the total number of ACLs availablefor use by the network operator. Enabling iSCSI Optimization uses one ACLlist to monitor for iSCSI sessions. Each monitored iSCSI session utilizes tworules from additional ACL lists up to a maximum of two ACL lists. Thismeans that the maximum number of ACL lists allocated by iSCSI is three.NOTE: This feature is not available on the N3000 when loaded with theAGGREGATION ROUTER-enabled firmware (e.g., N3000_BGPvA.B.C.D.stk).Commands in this SectionThis section explains the following commands:iscsi aging timeThe iscsi aging time command sets the time out value for iSCSI sessions. Toreset the aging time to the default value, use the no form of this command.Syntaxiscsi aging time timeno iscsi aging time• time — The number of minutes a session must not be active prior to it'sremoval. (Range: 1-43,200)Default ConfigurationThe default aging time is 10 minutes.Command ModeGlobal Configuration mode.iscsi aging time iscsi target portiscsi cos show iscsiiscsi enable show iscsi sessions
