Layer 3 Routing Commands 1498Prefix List Out....................... PfxList3Route Map In.......................... rmapUpRoute Map Out......................... rmapDown172.20.5.1Prefix List Out....................... PfxList12Routing Protocol.......................... OSPFv2Router ID................................. 6.6.6.6OSPF Admin Mode........................... EnableMaximum Paths............................. 32Routing for Networks...................... 172.24.0.0 0.0.255.255 area 010.0.0.0 0.255.255.255 area 1192.168.75.0 0.0.0.255 area 2Distance.................................. Intra 110 Inter 110 Ext 110Default Route Advertise................... DisabledAlways.................................... FALSEMetric.................................... Not configuredMetric Type............................... External Type 2RedistSource Metric Metric Type Subnets Dist List--------- ------- ----------- ------- ---------static default 2 Yes Noneconnected 10 2 Yes 1Number of Active Areas.................... 3 (3 normal, 0 stub, 0 nssa)ABR Status................................ YesASBR Status............................... YesRouting Protocol.......................... RIPRIP Admin Mode............................ EnableSplit Horizon Mode........................ SimpleDefault Metric............................ Not configuredDefault Route Advertise................... DisableDistance.................................. 120Interface Send Recv--------- ---- ----0/25 RIPv2 RIPv2show ip routeUse the show ip route command to display the current state of the routingtable. The output of the command also displays the IPv4 address of thedefault gateway and the default route associated with the gateway.This command deprecates the show ip route connected command.
