Layer 3 Routing Commands 1785Command ModeInterface Configuration (VLAN) mode.User GuidelinesThis command has no user guidelines.ExampleThe following example allows no RIP control packets to be sent by VLAN 11.console(config-if-vlan11)#ip rip send version noneredistribute (RIP)The redistribute command configures RIP protocol to redistribute routesfrom the specified sources. If the source protocol is OSPF, there are fivepossible match options.Syntaxredistribute ospf [metric integer] [match [internal] [external 1] [external 2][nssa-external 1] [nssa-external 2]]no redistribute [ospf | bgp | static | connected]redistribute {bgp | connected | static} [metric integer]• metric integer — Specifies the metric to use when redistributing the route.Range: 0-15.• match internal — Adds internal matches to any match types presentlybeing redistributed.• match external 1 — Adds routes imported into OSPF as Type-1 externalroutes into any match types presently being redistributed.• match external 2 — Adds routes imported into OSPF as Type-2 externalroutes into any match types presently being redistributed.• match nssa-external 1 — Adds routes imported into OSPF as NSSA Type-1 external routes into any match types presently being redistributed.• match nssa-external 2 — Adds routes imported into OSPF as NSSA Type-2 external routes into any match types presently being redistributed.• static — Redistributes static routes.
