Layer 2 Switching Commands 632Example #1console#show interfaces port-channel 1Channel Ports Ch-Type Hash Type Min-links Local Prf------- ----------------------------- -------- ---------- --------- --------Po1 Inactive: Gi1/0/1, Gi1/0/2, Dynamic 3 1 EnabledGi1/0/3, Gi1/0/4Hash Algorithm Type1 - Source MAC, VLAN, EtherType, source module and port ID2 - Destination MAC, VLAN, EtherType, source module and port ID3 - Source IP and source TCP/UDP port4 - Destination IP and destination TCP/UDP port5 - Source/Destination MAC, VLAN, EtherType, source MODID/port6 - Source/Destination IP and source/destination TCP/UDP port7 - Enhanced hashing modeshow lacpUse this command to display LACP information for Ethernet ports.Syntaxshow lacp {gigabitethernet unit/slot/port| tengigabitethernet unit/slot/port |fortygigabitethernet unit/slot/port}[parameters | statistics]Parameter DescriptionChannel Number of the port channel to show. This parameter isoptional. If the port channel number is not given, all thechannel groups are displayed. (Range: Valid port-channelnumber, 1 to 48).• Ports—The ports that are members of the port-channel.• Ch-Type—The aggregation scheme. Dynamic indicates thatthe LACP protocol is run.• Hash Algorithm Type—The hashing used to assign aconversation to a particular aggregation link.• Local Prf—An additional field added to support the displayof the local preference.
