Audio Visual Bridging Commands 1116Command HistoryIntroduced in version 6.2.0.1 firmware.ExampleThis example configures the switch with an initial log sync interval of 3.console(config-if-Gi1/0/1)#dot1as interval sync 3console(config-if-Gi1/0/1)#show dot1as interface gi1/0/1AS Interface Admin Mode................... EnabledAS Capable................................ NoIs Measuring Delay............................. NoPropagation Delay.............................. 0Port Role...................................... DisabledPDELAY Threshold............................... 2500PDELAY lost responses allowed.................. 3Neighbor Rate Ratio............................ 0Initial Sync Interval.......................... 3Current Sync Interval.......................... -3Initial Pdelay Interval........................ 0Current Pdelay Interval........................ 0Initial Announce Interval...................... 3Current Announce Interval...................... 0Sync Receipt Timeout........................... 3Announce Receipt Timeout....................... 3dot1as interval pdelayUse this command to configure the pdelay interval for an interface. Use theno form of the command to return the pdelay interval to the default.Syntaxdot1as interval pdelay int-valno dot1as interval pdelay• int-val—The initial pdelay interval in log base 2 format. The range is –5 to5.Default ConfigurationBy default, the pdelay interval is 0.
