Security Commands 931console(config)#radius-server source-ip 10.1.1.1radius-server source-interfaceUse the radius-server source-interface command to select the interface fromwhich to use the IP address in the source IP address field of transmittedRADIUS packets. Use the no form of the command to revert to the default IPaddress.Syntaxradius-server source-interface {loopback loopback-id | vlan vlan-id}no radius-server source-interface• loopback-id — A loopback interface identifier.• vlan-id—A VLAN identifier.Default ConfigurationBy default, the switch uses the assigned switch IP address as the source IPaddress for RADIUS packets. This is either the IP address assigned to theVLAN from which the RADIUS packet originates or the out-of-band interfaceIP address.Command ModeGlobal ConfigurationUser GuidelinesThe source IP address of RADIUS packets sent to a server should match theNAS IP address configured on the RADIUS server. A mismatch may lead to aRADIUS packet timeout.Loopback interfaces are not supported on the Dell EMC N1100-ON Seriesswitches.Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole#conf
