Layer 2 Switching Commands 638• Once configured, there is no network connectivity on the probe(destination) port. The probe port does not forward any traffic and doesnot receive any traffic. The probe tool attached to the probe port is unableto ping the networking device or ping through the networking device, andno device is able to ping the probe tool.• ACL attributes redirect, mirror, log, rate-limit, assign-queue, time-range,IGMP type, ICMP type, ICMP code, routing, fragments, and TCPestablished are not supported when applied to a mirroring session.Commands in this SectionThis section explains the following commands:monitor capture (Global Configuration)Use the monitor capture command to capture packets transmitted orreceived from the CPU. This facility captures switch control plane traffic andis useful in monitoring network control traffic and analyzing network security.No monitor capture file size returns the capture file size to the defaults.No monitor capture remote port returns the TCP port to the default.Syntaxmonitor capture {file size max-size | remote port id | line wrap}no monitor capture {file size |remote port |line wrap}• max-size—The size of the capture file in bytes.• id—The local (switch) TCP port for use with Wireshark.Default ConfigurationCapture is not enabled by default.monitor capture (Global Configuration) remote-spanmonitor capture (Privileged Exec) show monitor capturemonitor capture mode show monitor sessionmonitor session show vlan remote-span
