Security Commands 959dot1x max-usersUse the dot1x max-users command in Interface Configuration mode to setthe maximum number of clients supported on the port when MAC-based802.1x authentication is enabled on the port. Use the no version of thecommand to reset the maximum number of clients supported on the portwhen MAC-based 802.1x authentication is enabled on the port.Syntaxdot1x max-users usersno dot1x max-users• users — The number of users the port supports for MAC-based 802.1xauthentication (Range: 1–64)Default ConfigurationThe default number of clients supported on a port with MAC-based 802.1xauthentication is 64. The N1100-ON Series switches, the range is 1–32.Command ModeInterface Configuration (Ethernet) modeUser GuidelinesThe N1100-ON Series switches support up to 32 users per interface.ExampleThe following command limits the number of devices that can authenticateon port gigabitethernet 1/0/2 to 3.console(config-if-Gi1/0/2)#dot1x max-users 3dot1x port-controlUse the dot1x port-control command in Interface Configuration mode toconfigure the 802.1x mode of authentication on the port. Use the no form ofthe command to return the mode to the default.
