Layer 3 Routing Commands 1333Modified in version 6.3.0.1 firmware.Exampleconsole#show bgp ipv6 neighbors fe80::1 vlan 10 policyNeighbor Policy Template--------------- ------------------------------------------------ -----------fe80::1%Vl0010activateprefix-list jupiter inprefix-list saturn outmaximum-prefix 2000send-communityshow bgp ipv6 neighbors received-routesUse this command to display a list of IPv6 routes received from a specificneighbor. The list includes either all routes received from the neighbor,received routes that passed inbound policy, or routes rejected by inboundpolicy. The output and format as the same as for show IP bgp neighborsreceived-routes, except that they list IPv6 routes. Also, the command displaysa list of IPv4 routes received from a specific neighbor with RFC5549.This command deprecates and replaces the show ipv6 bgp neighborsreceived-routes command.Syntaxshow bgp ipv6 neighbors { ipv4-address | ipv6-address [ interface interface-id] | autodetect interface interface-id } { received-routes | routes | rejected-routes }• ipv4-address—The IPv4 address of a BGP peer• ipv6-address interface interface-id—The IPv6 address of a BGP peer. If thepeer address is an IPv6 link local address, the interface that defines thescope of the link local address must be given.• autodetect interface interface-id —(Optional) The routing interface onwhich the neighbor’s link local IPv6 address is auto detected. Theinterface-id must be a VLAN routing interface.
