Security Commands 865• encrypted — Encrypted password entered, copied from another switchconfiguration.Default ConfigurationThis command has no default configuration.Command ModeGlobal Configuration modeUser GuidelinesThe Dell EMC Networking firmware emulates industry standard behavior forenable mode authentication over SSH and telnet. The default enableauthentication method for telnet and SSH uses the enableNetList method,which requires an enable password. If users are unable to enter privilegedmode when accessing the switch via telnet or SSH, the administrator willneed to either change the enable authentication method, e.g. to enableList,or set an enable password. If the encrypted parameter is specified, thepassword parameter is stored as entered in the running-config. No attempt ismade to decode the encrypted password. To use the ! character as part of theusername or password string, it should be enclosed within quotation marks.For example, username “test!xyz” password “test!xyz”.ExampleThe following example defines password “xxxyyyzzz” to control access to userand privilege levels.console(config)# enable password xxxyyyzzzip http authenticationUse the ip http authentication command in Global Configuration mode tospecify authentication methods for http server users. To return to the default,use the no form of this command.Syntaxip http authentication method1 [method2...]no ip http authentication
