Layer 3 Routing Commands 1339Default Hold Time ............................. 90Number of Network Entries ..................... 0Number of AS Paths ............................ 0Dynamic Neighbors Current/High/Limit .......... 1/1/20Default Metric ................................ Not ConfiguredDefault Route Advertise ....................... NoRedistributing:Source Metric Dist List Route Map--------- ---------- -------------------------------- ----------------------Neighbor ASN MsgRcvd MsgSent State Up/Down Time Pfx Rcvd---------------- ----- -------- -------- ------------- -------------- ------fe80::21e:c9ff:fede:b13a%Vl1065000 137 136 ESTABLISHED 0show bgp ipv6 update-groupUse this command to report the status of IPv6 outbound groups and theirmembers. Output and format are the same as for show ip bgp update-group.This command deprecates and replaces the show ipv6 bgp update-groupcommand.Syntaxshow bgp ipv6 update-group [ group-index | ipv4-address | ipv6-address [interface interface-id ] | autodetect interface interface-id ]• group-index—If specified, this option restricts the output to a singleupdate group.• ipv4-address—The IPv4 address of a peer enabled for exchange of IPv6prefixes. If specified, this option restricts the output to the update groupcontaining the peer with the given address.• ipv6-address [ interface interface-id ]—The IPv6 address of a peer. If thepeer address is a link local address, the interface that defines the scope ofthe address must also be given. If a peer address is specified, this optionrestricts the output to the update group containing the peer with the givenaddress.• autodetect interface interface-id —(Optional) The routing interface onwhich the neighbor’s link local IPv6 address is auto detected. Theinterface-id must be a VLAN routing interface.
