Switch Management Commands 2150User GuidelinesThis command is not supported on Dell EMC N1100-ON switches. DellEMC N1100-ON switches support configuration of a single IP address ininterface vlan configuration mode. That IP address is used as the sourceinterface address for this function..Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole#confconsole(config)#interface vlan 1console(config-if-vlan1)#ip address dhcpconsole(config-if-vlan1)#exitconsole(config)#logging source-interface vlan 1logging trapsUse the logging traps command in Global Configuration mode to set thelowest severity level at which SNMP traps are logged. To revert the urgentseverity level to its default value, use the no form of this command.Syntaxlogging traps severityno logging traps• severity—If you specify a severity level, log messages at or above theseverity level are e-mailed. The severity level may either be specified bykeyword or as an integer from 0 to 7. The accepted keywords, and thenumeric severity level each represents, are as follows.– emergency (0)– alert (1)– critical (2)– error (3)– warning (4)– notice (5)
