Switch Management Commands 1947IP Addressing CommandsDell EMC Networking N1100-ON/N1500/N2000/N2100-ON/N3000/N3100-ON/N4000 Series SwitchesInterfaces on the Dell EMC Networking switches support a variety ofcapabilities to support management of the switch. In addition to performingswitching and routing of network traffic, Dell EMC Networking switches actas a host for management of the switch. Commands in this category allow thenetwork operator to configure the local host address, utilize the embeddedDHCP client to obtain an address, resolve names to addresses using DNSservers, and detect address conflicts on the local subnet.There are two management interface types on Dell EMC Networkingswitches. In-band interfaces allow management of the switch through thenetwork switching/routing interfaces. Out-of-band management is alwaysthrough the dedicated out-of-band interface. The serial port on the stackmaster provides a direct console interface supporting a CLI. In-bandmanagement interfaces can employ a variety of protection mechanismsincluding VLAN assignment and Management ACLs. The out-of-band portdoes not support such protection mechanisms and, therefore, it isrecommended that the out-of-band interface only be connected to aphysically segregated management network.Commands in this SectionThis section explains the following commands:clear host ip name-server source-interfaceclear ip address-conflict-detect ipv6 address (Interface Configuration)interface out-of-band ipv6 address dhcpip address ipv6 enable (Interface Configuration)ip address (Out-of-Band) ipv6 enable (OOB Configuration)ip address-conflict-detect run ipv6 gateway (OOB Configuration)ip address dhcp (Interface Configuration) show hostsip default-gateway show ip address-conflict
