Layer 2 Switching Commands 610mvr typeUse the mvr type command in Interface Configuration mode to set the MVRport type. Use the no form of this command to set the MVR port type toNone.Syntaxmvr type {receiver | source}no mvr type• receiver—Configure the port as a receiver port. Receiver ports are portsover which multicast data will be sent but not received.• source—Configure the port as a source port. Source ports are ports overwhich multicast data is received or sent.Default ConfigurationThe default value is None.Command ModeInterface ConfigurationUser GuidelinesThe following table lists the completion messages.Exampleconsole(config)#mvrconsole(config)#mvr group 239.1.1.1console(config)#vlan 99console(config-vlan99)#exitconsole(config)#interface Gi1/0/1console(config-if-Gi1/0/1)#switchport access vlan 10console(config-if-Gi1/0/1)#mvrMessage Type Message DescriptionSuccessful Completion Message NoneError Completion Message • Port is a Trunk port, operation failed.• Receiver port in mVLAN, operation failed.
