Layer 2 Switching Commands 494Exampleconsole(config)#show errdisable recoveryReason Auto-recovery Status------------------ ---------------------ARP Inspection DisabledBPDU Guard DisabledBroadcast Storm DisabledBPDU Storm DisabledDHCP Rate Limit DisabledLoop Protect DisabledMulticast Storm DisabledSFP Mismatch DisabledSFP Plus Mismatch DisabledUDLD DisabledUnicast Storm DisabledPort MAC Locking DisabledDenial of Service DisabledInterval for auto-recovery of error disabled interfaces: 300 secondsshow interfaces status err-disabledUse the show interfaces status err-disabled command to display theinterfaces that are error disabled by the system.Syntaxshow interfaces status err-disabledDefault ConfigurationNo recovery causes are enabled by default.Command ModePrivileged Exec mode, Global Configuration mode and all submodesUser GuidelinesError disabled interfaces indicate that a problem that must be resolved by theadministrator. This could be a configuration problem or a physical problemand does not necessarily indicate a problem with the switch.
