Switch Management Commands 2190show buffersUse the show buffers command to display the system allocated buffers.Syntaxshow buffersDefault ConfigurationThere is no default configuration.Command ModePrivileged Exec mode, Global Configuration mode and all ConfigurationsubmodesUser GuidelinesThe internal message buffers are partitioned into one transmit group reservedfor system generated messages and five receive priority groups. The receivepriority groups are processed in strict priority order starting with the Highgroup and proceeding down through the Mid0, Mid1 and Mid2 groups downto the Normal group. Small numbers of buffer failures in the low prioritygroups (Norm, Mid2, Mid1) may occur without affecting system operation,(for example, loss of an LLDP packet is not likely to cause any noticeablesystem disruption).Command HistoryIntroduced in version 6.2.0.1 firmware.Exampleconsole#show buffersMessage Buffer Utilization--------------------------0 of 246 total buffers usedReceive Attempts Failures %Failure-------------------------------------------------Norm 0 0 0%Mid2 0 0 0%
