Layer 2 Switching Commands 492User GuidelinesError disabled interfaces indicate that a problem that must be resolved by theadministrator. This could be a configuration problem or a physical problemand does not necessarily indicate a problem with the switch.When the interval expires, the system examines the error disabled interfacesand recovers them if recovery for the indicated cause is enabled. Only a singletimer is used and recovery occurs when the timer expires, not when theinterface time expires.Interfaces recovered by auto-recovery issue a log message indicating thatrecovery is being attempted.<13> Sep 25 14:38:32 10.130.135.107-1 UDLD[nim_t]: udld_util.c(1829) 87 %%Interface Gi1/0/1 is restored from the error disabled state.Command HistoryImplemented in version 6.3.0.1 firmware.ExampleThe following example sets the error recovery timer to 30 seconds.console(config)#errdisable recovery interval 30show errdisable recoveryUse the show errdisable recovery command to display the error disableconfiguration for each possible cause.Syntaxshow errdisable recoveryDefault ConfigurationBy default, no recovery causes are enabled.Command ModeGlobal Configuration mode
