Security Commands 860Default ConfigurationThe default value is Disabled.Command ModeGlobal Configuration modeUser GuidelinesThe administrator must ensure that any methods configured by theAuthentication Manager are enabled (e.g. enable IEEE 802.1x using thedot1x system-auth-control command). Enable MAB using the dot1x mac-auth-bypass command.Exampleconsole(config)# authentication enableauthentication orderThis command sets the order of authentication methods used on a port. Theavailable authentication methods are Dot1x, MAB, and captive portal.Ordering sets the order of methods that the switch attempts when trying toauthenticate a new device connected to a port. If one method is unsuccessfulor timed out, the next method is attempted.Use the no form of this command to return the port to the defaultauthentication order.Syntaxauthentication order {dot1x [mab][captive-portal] | mab [dot1x] [captive-portal] | captive-portal}no authentication orderDefault ConfigurationThere is no default configuration for this command.Command ModesInterface Configuration (Ethernet) mode
