Switch Management Commands 1987Gi1/0/1 OKGi1/0/2 Short 50 13:32:00 23 July 2004Gi1/0/3 Test has not been performedGi1/0/4 Open 128 13:32:08 23 July 2004Gi1/0/5 Fiber - -show fiber-ports optical-transceiverUse the show fiber-ports optical-transceiver command to display the opticaltransceiver diagnostics.Syntaxshow fiber-ports optical-transceiver [interface]• interface — A valid SFP, XFP or SFP+ port.Default ConfigurationThis command has no default configuration.Command ModePrivileged Exec mode, Global Configuration mode and all ConfigurationsubmodesUser GuidelinesThe show fiber ports command is applicable to all fiber ports, including SFP,SFP+, and XFP ports. It will display an error if executed against a copper portor passive or active direct attach cables.ExamplesThe following examples display the optical transceiver diagnostics.console#show fiber-ports optical-transceiverOutput InputPort Temp Voltage Current Power Power TX LOS[C] [Volt] [mA] [dBm] [dBm] Fault--------- ---- ------- ------- ------- ------- ----- ---Te2/0/23 22.5 3.296 7.5 -2.184 -36.990 No Yes
