Layer 3 Routing Commands 1662Database Description packet is rejected and the OSPF adjacency is notestablished. Use the no form of the command to enable OSPF maximumtransmission unit (MTU) mismatch detection.Syntaxip ospf mtu-ignoreno ip ospf mtu-ignoreDefault ConfigurationThis command has no default configuration.Command ModeInterface Configuration (VLAN) mode.User GuidelinesThis command has no user guidelines.ExampleThe following example disables OSPF MTU mismatch detection on VLANinterface 15.console(config-if-vlan1)#ip ospf mtu-ignoreip ospf networkUse the ip ospf network command to configure OSPF to treat an interface asa point-to-point rather than broadcast interface. To return to the defaultvalue, use the no form of this command.Syntaxip ospf network {broadcast | point-to-point}no ip ospf network• broadcast — Set the network type to broadcast.• point-to-point — Set the network type to point-to-point
