Layer 3 Routing Commands 1666Use the no form of the command to disable state change logging.Syntaxlog-adjacency-changes [detail]no log-adjacency-changes [detail]• detail—(Optional) When this keyword is specified, all adjacency statechanges are logged. Otherwise, OSPF only logs transitions to FULL stateand when a backwards transition occurs.Default ConfigurationAdjacency changes are not logged by default.Command ModeOSPFv2 Router Configuration modeUser GuidelinesState changes are logged with INFORMATIONAL severity.max-metric router-lsaUse the max-metric router-lsa command in router OSPF GlobalConfiguration mode to configure OSPF to enable stub router mode.To disable stub router mode, use the no max-metric router-lsa command inOSPFv2 Global Router Configuration mode.Syntaxmax-metric router-lsa [on-startup seconds] [summary-lsa {metric}]no max-metric router-lsa [on-startup] [summary-lsa]• on-startup—(Optional) OSPF starts in stub router mode after a reboot.• seconds—(Required if on-startup) The number of seconds that OSPFremains in stub router mode after a reboot. The range is 5 to 86,400seconds. There is no default value.• summary-lsa—(Optional) Set the metric in type 3 and 4 summary LSAs toLsInfinity (0xFFFFFF).
