Layer 3 Routing Commands 1216ASNs 0, 56320–64511, and 65535 are reserved and cannot be used.Command HistoryIntroduced in version 6.2.0.1 firmware.ExampleThe following example creates a BGP routing instances and enables BGProuting for AS 4324.console(config)#router bgp 4324address-familyUse the address-family command in peer template configuration mode toconfigure policy parameters within a peer template to be applied to a specificaddress family. To delete all policy commands for an address family in a peertemplate, use the no form of this commandSyntaxaddress-family { ipv4 | ipv6 }no address-family { ipv4 | ipv6 }• ipv4—Configure policy parameters to be applied to IPv4 routes.• ipv6—Configure policy parameters to be applied to IPv6 routes.Default ConfigurationNo peer templates are configured by default.Command ModePeer Template Configuration modeUser GuidelinesThis command enters address family configuration mode within the peertemplate. Policy commands configured within this mode apply to the addressfamily. The following commands can be added to a peer template in addressfamily configuration mode:• activate
