Switch Management Commands 2184Command ModesUser Exec mode on the stack master. Unit prompt on the stack member.User GuidelinesThis command is available in User Exec mode on the master unit serial portand from the Unit prompt on member unit serial ports. The user need not becurrently connected over the serial port to connect to another unit.The stack member being connected to must be up and running andconnected as part of the stack.This command is an alias for the exit command.ExampleExample 1:To disconnect a remote session to the stack master established from a stackmember.(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1Stack-Master#Stack-Master#quit(Unit 2 - CLI unavailable - please connect to master on Unit 1)>Example 2:To disconnect a remote session to the stack master established from stackmember.(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1Stack-Master#exitStack-Master>quit(Unit 2 - CLI unavailable - please connect to master on Unit 1)>reloadUse the reload command to reload stack members.The reload command checks for stack port errors prior to reloading stackmembers and after the check for unsaved configuration changes. If stack porterrors are found, a message is displayed.Syntaxreload [stack–member–number]
