Layer 2 Switching Commands 683Syntaxmatch cos• cos-value — Specifies the CoS value as an integer (Range: 0–7)Default ConfigurationThis command has no default configuration.Command ModeClass-Map Configuration modeUser GuidelinesThis command has no user guidelines.ExampleThe following example displays adding a match condition to the specifiedclass.console(config-classmap)#match cos 1match destination-address macUse the match destination-address mac command in Class-MapConfiguration mode to add a match condition based on the destination MACaddress of a packet.NOTE: This command is not available on the N1500 Series switches.Syntaxmatch destination-address mac macaddr macmask• macaddr — Specifies any valid layer 2 MAC address formatted as six two-digit hexadecimal numbers separated by colons.• macmask — Specifies a valid layer 2 MAC address bit mask formatted assix two-digit hexadecimal numbers separated by colons. This address bitmask does not need to be contiguous.
