Switch Management Commands 2124Syntaxenableno enableDefault ConfigurationBy default, the default server is enabled. It may be disabled using the noenable form of the command.Command ModeSupport Assist ConfigurationUser GuidelinesOnly one SupportAssist server may be enabled. If contact with the server fails,the switch sleeps for the quiet period (default 1 hour) before attemptingcontact again.Command HistoryIntroduced in version 6.3.0.1 firmware.Exampleconsole(config)# support-assistconsole(conf-support-assist)#server New-Serverconsole(conf-support-assist-NewServer)#enableproxy-ip-addressUse the proxy-ip-address command to configure a proxy server to be used tocontact the SupportAssist servers. Use the no form of the command toremove the proxy server information.Syntaxproxy-ip-address {ipv4-address | ipv6-address} port port-number usernameuserid password [encryption-type] passwordno proxy-ip-address• ipv4-address — The IPv4 address of the proxy server in dotted decimalnotation.
