Switch Management Commands 2129support-assistUse the support-assist command to enable support-assist configuration modeif the EULA has been accepted. Use the no form of the command to removethe configured SupportAssist information.Syntaxsupport-assistno support-assistDefault ConfigurationBy default, a server named “default” is configured. It may be disabled by theadministrator.Command ModeGlobal ConfigurationUser GuidelinesThis command enters support-assist-conf mode. It allows the administratorto configure SupportAssist information. The configured information is storedin the running config. Use the write command to save the information intothe startup-config.Command HistoryIntroduced in version 6.3.0.1 firmware.ExamplesExample 1In this example, the SupportAssist EULA has been accepted.console(config)#support-assistconsole(conf-support-assist)#Example 2In this example, the SupportAssist EULA has been rejected.console(config)#support-assist
