Data Center Technology Commands 1150traffic-class-group max-bandwidthUse this command in Global Config or Interface Configuration mode tospecify the maximum transmission bandwidth limit for each TCG as apercentage of the interface rate. Also known as rate shaping, this has theeffect of smoothing temporary traffic bursts over time so that the transmittedtraffic rate is bound.Syntaxtraffic-class-group max-bandwidth bw-0 bw-1 … bw-nno traffic-class-group max-bandwidth• bw-0..7—The maximum percentage bandwidth to be transmitted by theTCG. Range 0 to 100.Default ConfigurationThe default maximum bandwidth for all TCGs is 0% (unlimited).Command ModeGlobal Config, Interface Configuration modesUser GuidelinesNOTE: This command is only available on N40xx series switches.This command specified in Interface Configuration mode only affects asingle interface; whereas, the Global Configuration mode setting is applied toall interfaces. Interface configuration overrides the global configuration onthe designated interface. The Interface Configuration mode command is onlyavailable on platforms that support independent per-port class of servicequeue configuration.Each bw-x value is a percentage that ranges from 0 to 100 in increments of 1.All n bandwidth values must be specified with this command and each isindependent of the others. The number n is platform dependent andcorresponds to the number of supported traffic classes groups. The defaultmaximum bandwidth value for each TCG is 0, meaning no upper limit isenforced, which allows the TCG queue to consume any available non-guaranteed bandwidth of the interface.