Layer 2 Switching Commands 513Default ConfigurationListener message suppression is enabled by default.Command ModeGlobal Configuration mode.User GuidelinesMLD listener message suppression is equivalent to IGMP report suppression.When MLD listener message suppression is enabled, the switch only sendsthe first report received for a group in response to a query. Listener messagesuppression is only applicable to MLDv1.Exampleconsole(config)#ipv6 mld snooping vlan 10 listener-message-suppressionipv6 mld snooping vlan last-listener-query-intervalThe ipv6 mld snooping vlan last-listener-query-interval command sets thenumber of seconds after which a host is considered to have left the group.This value must be less than the MLD Query Interval time value. The rangeis 1 to 25 seconds.Syntaxipv6 mld snooping vlan vlan-id last-listener-query-interval timeno ipv6 mld snooping vlan vlan-id last-listener-query-interval• vlan-id — A VLAN identifier (Range 1-4093).• time — The number of seconds after which a host is considered to haveleft the group. (Range: 1–25 seconds)Default ConfigurationThe default maximum response time is 10 seconds.Command ModeGlobal Configuration mode
