Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 133C ONFIGURING SYSTEM O PTIONS AND I NFORMATIONAdministrative Session4. You may specify an authentication database location for administrative sessions that isdifferent from the user authentication database location.Note: If you select RADIUS, TACACS, or ACE, you must be sure that the selected server isactive before you initiate an administrative session.5. From the Administrative Session menu select (2) Session Inactivity Timeout. The followingprompt is displayed:6. Follow the onscreen instructions to set the session inactivity timeout session.7. From the Administrative Session menu, select (3) Number of Admin Telnet Sessions. Thefollowing prompt is displayed:8. Follow the onscreen instructions to configure the number of administrative Telnet sessions youwish to allow. Up to three sessions are possible.Note: To have any Telnet sessions, you must first enable IP.9. To change the value of the port number, select (4) Telnet Server TCP Port Number from the fromthe Administrative Session menu.10. Follow the onscreen instructions for entering the port number.11. Select option (5) Emergency Telnet Server Port Number from the Administrative Session menu.12. Follow the onscreen prompts to configure the port number.U SING M ANAGE M ODEadmloginDisplays the current administration session configuration.admlogin changeDisplays the Administration Session Configuration Menu screen, allowing you to change theauthentication database location. Refer to Using CFGEDIT for configuration instructions.ADMINISTRATIVE SESSION CONFIGURATION ELEMENTSD ATABASE LOCATIONThe authentication database location for administration sessions. This database location may bedifferent from the user authentication database. The default database location is the on-node devicedatabase.Enter the Session Inactivity Timeout value in minutes.Use "0" to disable the Session Inactivity Timeout [default = disabled]?Enter the number of Telnet allowed for administrative sessions.Use "0" to disable the Telnet Server [default = 3]? 1