|
Small Office Remote Access Switch 513S YSTEM COMMANDSFrame Relay Commandsip addrpoolDisplays the current IP address pool. Refer to theip addrpool command description underIP Routing Commands.F RAME R ELAY C OMMANDSThe following commands are used to display information concerning both the status and trafficstatistics of a particular frame relay connection.fr a n>Sets an internal variable. The frame relay will be the assumed current access forall subsequent frame relay system console commands entered. will remain thecurrent access, until it is changed through issuing anotherfr a command. The is the access index that is assigned to each frame relay access during the frame relayaccess configuration.Note that this command may be used in conjunction with all otherfr commands. For example,fr a 1 lmi would be a valid command, changing the frame relay access to 1 beforedisplaying information relating to the LMI link.fr d m>Sets an internal variable. m> will be the default DLCI under the currently-selectedaccess, and therefore the assumed context for all subsequent frame relay system consolecommands entered. <DLCI m> will remain the default DLCI until the default is changedthrough reissuing thefr d command. The DLCI value is provided by the serviceprovider at line subscription time.For the following frame relay commands, information is displayed for the currently selected access.However, you may also change the access (which, in turn, changes the default) by using thesecommands along with the access index command. Refer to thefr a n> command.fr displayDisplays the configuration information as entered during the last CFGEDIT session for thecurrently-selected frame relay access. Note that this also includes any configured PVCsassociated with this access.fr statsDisplays the statistics associated with the currently-selected access and DLCI. Refer to FrameRelay Statistics, for a list of available statistics and their definitions.fr clearClears the statistics counters associated with thefr stat command for the currently selectedaccess and DLCI.fr clearallClears all statistics associated with thefr stat command.fr lmiDisplays information relating to the LMI link on the currently-selected frame relay access, ifthat access has the layer Management Interface enabled. The following list describes the fieldsdisplayed when the FR LMI command is entered. PreviousNext |