| 
Small Office Remote Access Switch 447SYSTEM M ESSAGESSystem Message Summarysystem to start dialing. Contact the telephone company and ensure that the line is configured forwink-start.RBS: Unexpected event chan = , state = An illegal signaling event occurred in the RBS task on the specified channel. Ensure that the line isconfigured correctly and that it is using the expected RBS protocol. Excess noise on the line mayalso cause this event.Read 0 bytes from file for WAN card in slot If seen repeatedly, the above message indicates a problem with your hard drive. Contact yourDistributor or Customer Support.Ready for XModem Download - to abortThe user has requested an attempt to UPDATE the system software, or it was not possible to Bootthe system the last time it was attempted.Reattempting to Install File Set into Flash MemoryThe SSB is re-attempting to install the FileSet. The Flash File System may have been corrupted whenattempting to install the FileSet the first time. In the meantime, the Flash File System has beenformatted.Rebooting...The system is going to wait until the WatchDog timer expires, which causes the entire system toreboot.Received charge amount - The system has received an advice of charge from the network for the call just disconnected. Thecharge for this call is indicated in the charge amount parameter.Received CLLM while PVC for DLCI in unexpected state A CLLM message was received indicating that a network condition should be expected for the PVCassociated with the indicated DLCI. However, this PVC is in the indicated state and as such isalready acting on a previous network condition notification.Remote peer ID discrepancyThe On-node Device Table and the remote end of the connection disagree on the identity of theremote end. Check configuration, and then reboot the remote device. If problem persists, contactyour Distributor or Customer Support.Replace Lithium Battery: Contact your RepresentativeIf this message is displayed in the log messages, contact your Distributor or Customer Supportbefore you power off your system.Requested channel not available - The system has attempted a call using a channel on the indicated line that was not available. Thecall will be retried over a different line if possible.Reserved signalThis message is informational only and is used to indicate additional details on the received in the “call progress” information message. |
