Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

Small Office Remote Access Switch 519S YSTEM COMMANDSIPX Routing Commandsip route address>Displays the routing information for the indicated device. The meaning of each displayed fieldfor a route entry is included in the aboveip route command explanation.ip statsDisplays the current IP related statistics. Refer to IP Statistics, for a list of available statistics andtheir definitions.IPX R OUTING COMMANDSIPX routing must be enabled before these commands can be used.The following commands are used to display IPX routing information:ipx ipxwan clearClears IPXWAN statistics.ipx ipxwan stats (device)Displays system-level IPXWAN statistics when device name not specified:Displays Negotiation Parameters when device name specified and connected:ipx diag ipx address> [timeout]Tests device connectivity to specified IPX host by sending out a diag packet. If connection is up,host sends a message in response to this packet to confirm receipt. The parameters for thiscommand are:host ipx addressIPX address for the host, in : format. The network numberis a hexadecimal number up to eight digits in length. The node number is the host’s MACaddress. For example, if the assigned network number of “AAAA,” and the host has a MACaddress of 40AA68965439. For this example, you would enter “AAAA:40AA68965439” for thehost IPX address.timeoutIPXWAN StatisticsTimer Request = Timer Response =Information Request = Information Response =Thruput Request = Thruput Response =Delay Request = Delay Response =NACK Sent = NACK Received =Bad Packets =WAN Statistics for device “xxxx”Negotiation Parameters:IPX Network Address = IPX Node Number =Telebit Compression = Protocol =WAN Link Delay =