Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE508 CyberSWITCHThe TYPE field is Ethernet type field of the LAN frame. This hexadecimal field represents theprotocol identifier for an Ethernet formatted frame. For an 802.3 formatted frame, it is thelength of the data unit.The COUNT field is the number of frames transferred for that destination address, sourceaddress, and Ethernet type combination. The total number of frames is displayed at the bottomof the screen.To exit the MAC Address Monitor screen and disable the feature, press on theAdministration console keyboard.br statsDisplays the current system packet statistics. Refer to Bridge Statistics, for a list of availablebridge statistics and their definitions.br stats clearClears the current system packet statistics.C ALL C ONTROL COMMANDSThe following commands are used to initiate and disconnect calls to devices.call device name>Initiates a call to the specified device. The entire device name does not need to be entered; onlyenough letters of the name to distinguish it from any other configured device name. Forexample, you could entercall device sm if there are no other devices whose names beginwithsm. The call device command can be used to test the Dial Out capability to a specificdevice. This command is available only when the Authentication mode is “On-node DeviceTable.” To obtain the device name, enter the Manage Mode and issue thedevice command.Note that the device name is case sensitive.To use this command for troubleshooting, you must use the System Call Trace feature tocapture any connect and disconnect messages that are generated by issuing thecall devicecommand. To do this:1. Erase the current report log by enteringer at the system prompt.2. Enable the Call Trace feature by enteringtrace on at the system prompt.3. Issue thecall device name> command.4. Display the system log messages by entering thedr command at the system prompt.5. Check the log report for connect messages relating to the remote device you are testing.In response to thecall device command, one of the following responseswill be displayed:Calling device Indicates that a call request process has been initiated.