Cabletron Systems CyberSWITCH CSX150 User Manual

Also see for CyberSWITCH CSX150: User guide Quick start guide

Contents

USER’S GUIDE142 CyberSWITCHa. Enable or disable IPX routing.b. If you enable IPX routing and want dial-out capabilities to this device, enable the Make Callsfeature.c. If you enable IPX routing, you may enable or disable IPXWAN protocol.d. If you enable IPX routing, select IPX Routing Protocol. Select a routing protocol of none, RIP/SAP, or Triggered RIP/SAP. When you select Triggered RIP/SAP, you will need to identifythe WAN peer type as either active or passive.e. You may also select Spoofing Options. Make changes to default spoofing setup, if desired.Refer to IPX Information for Devices and Configuration Elements for more information.11. To enter any needed AppleTalk information for your device, select AppleTalk from the DeviceTable Menu. The following screen will be displayed:a. Press 1 at the above menu, then follow the on-screen instructions to enable AppleTalkrouting for the device.b. Press 2 at the above menu to enter the device’s AppleTalk address. If the device is over anunnumbered link, enter 0.0. If the device is over a MAC dial-in port, you may either enteran address, or leave the value at “none”.c. Press 3 at the above menu, then follow the on-screen instructions to configure whether ornot dial out to this device is allowed for this device.d. Press 4 at the above menu to specify an AppleTalk routing protocol the system should usewith this device. The options are None or RTMP. Currently RTMP is only supported fordevices who will be dialing into the CyberSWITCH via a MAC dial-in port.Note: If you are configuring a device for AppleTalk Remote LAN, leave the above AppleTalkinformation at the default values (DISABLED, None, DISABLED, None).Refer to AppleTalk Configuration Elements for more information.12. To enter any needed bridge information for this device, select Bridge from the Device TableMenu. The following screen will be displayed:You may enable or disable bridging for this device. If this device is to use a Remote LANinterface or Remote LAN port, enable bridging. If you want dial out capabilities to this device,enable Make calls for Bridge data.Device AppleTalk Menu: (device = “DAN”)1) AppleTalk Routing DISABLED2) AppleTalk Address None3) Make calls for AppleTalk data DISABLED4) AppleTalk Routing Protocol NoneSelect function from above or for previous menu: 1Device Bridging: (device = "DAN")1) IP (Sub)Network number NONE2) Bridging ENABLED3) Make Calls for Bridge data NONE4) IPX Remote LAN Network Number NONE5) IPX Spoofing Options6) AppleTalk Network Number NONESelect function from above or for previous menu: